Low clearance upper link mount for REAR STEER with third member turned 180 degrees, pinion on long side. This mount trades height for width to allow an upper triangluated system. Mount uses 3/8" plate for the towers, faceplate, and gussets and 5/16" plate for the top cap. Joint spacing 14 1/2" from center of joint to center of joint. Upper tabs are angled out at 18 degrees from vehicle centerline. Top of axle tube to lower hole 6.63", middle hole 7.63" and upper hole 8.63". Designed for 2.63" joint widths, but inner tabs can be moved for lesser widths. Top inspection cover cannot be removed without removing link mount. Sold as an unwelded, unpainted kit. Grade 8 side plate tower to faceplate hardware, longer pinion bearing flange and bull gear bearing flange hardware included. Shown unwelded.